Chrysler Town and Country With 3.6L Leaking Oil (Look HERE first)
Affiliate Disclosure: As an Amazon Associate, we may earn commissions from qualifying purchases from Amazon.com.
Here is a list of tools I use every day at the shop. Let me know if you use them too in the comments!
The 3.6-liter engine from Chrysler has become a headache for Chrysler Town and Country owners. From misfires, losing coolant, and leaking oil the 3.6-liter engine has been a nightmare. In this article, we will look at a common leak that plagues the 3.6-liter engines.
What years did the Chrysler Town and Country have the 3.6-liter engine?
The 3.6-liter engine was introduced in the 2011 Chrysler Town and Country models and ended in 2016.
What would cause a Chrysler Town and Country to leak oil?
The most common cause of an oil leak for a Chrysler Town and Country with a 3.6-liter engine is the oil cooler/oil filter housing.
Many mechanics will instantly look at the oil cooler/oil filter housing on these engines as soon as they are aware of an oil leak.
Where is the oil cooler/oil filter housing located?
The oil cooler/oil filter housing is located in the “V” of the 3.6-liter engine. It is below the lower intake manifold.
What are some signs that my oil cooler/oil filter housing is leaking?
One of the main signs is an oil leak running down the back of the engine. The leaking oil puddles up in the “V” of the engine and then runs down the back. This kind of leak can also run onto the transmission.
What does the oil cooler/oil filter housing do?
The oil cooler/oil filter housing is used to filter and then cool the engine oil before it is to be used again.
What causes the oil cooler/oil filter housing to go bad?
The o-rings on the bottom of the oil cooler/oil filter housing leak over time. In some cases, the oil cooler/oil filter housing will become cracked and start to leak.
How hard is it to replace the oil cooler/oil filter housing?
Replacing one of these components can be challenging for the less experienced mechanic. Special tools like a fuel line disconnect tool and a plastic clip remover are needed.
Multiple parts have to be taken off, like the upper and lower intake manifolds, to reach the oil cooler/oil filter housing.
With the upper and lower intake manifolds off, the intake valves are exposed. Small parts, like bolts, can easily fall into the cylinders if you are not careful.
How much does it cost to fix a Chrysler Town and Country oil leak?
If it is your oil cooler/oil filter housing that is leaking, it may cost $100-$250 for the part itself. Depending on the mechanic’s labor rate, it can cost up to $900.
Disclaimer and Disclosure:
Due to factors beyond the control of DiagnosticMechanic.com, it cannot guarantee against unauthorized modifications of this information, or improper use of this information. DiagnosticMechanic.com assumes no liability for property damage or injury incurred as a result of any of the information contained in this website. DiagnosticMechanic.com recommends safe practices when working with power tools, automotive lifts, lifting tools, jack stands, electrical equipment, blunt instruments, chemicals, lubricants, or any other tools or equipment seen or implied in this website. Due to factors beyond the control of DiagnosticMechanic.com, no information contained in this website shall create any express or implied warranty or guarantee of any particular result. Any injury, damage or loss that may result from improper use of these tools, equipment, or the information contained in this website is the sole responsibility of the user and not DiagnosticMechanic.com.
DiagnosticMechanic.com is a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for sites to earn advertising fees by advertising and linking to Amazon.com. In many of our case studies, articles, and tool reviews, we may earn a small commission when readers purchase products through our links.