Ram ProMaster With 3.6L Leaking Oil (Look HERE first)

 
3.6 oil leak on a Ram ProMaster
 

Affiliate Disclosure: As an Amazon Associate, we may earn commissions from qualifying purchases from Amazon.com.

Here is a list of tools I use every day at the shop. Let me know if you use them too in the comments!


The 3.6-liter engine from Chrysler has become a headache for Ram ProMaster owners. From misfires, losing coolant, and leaking oil the 3.6-liter engine has been a nightmare. In this article, we will look at a common leak that plagues the 3.6-liter engines.

What year of Ram ProMaster has the 3.6-liter engine?

The 3.6-liter engine was introduced in the 2013 Ram ProMaster models and is available through the present models.

What would cause a Ram ProMaster to leak oil?

The most common cause of an oil leak for a Ram ProMaster with a 3.6-liter engine is the oil cooler/oil filter housing.

Many mechanics will instantly look at the oil cooler/oil filter housing on these engines as soon as they are aware of an oil leak.

 
3.6 oil filter housing on a Ram ProMaster
 

Where is the oil cooler/oil filter housing located?

The oil cooler/oil filter housing is located in the “V” of the 3.6-liter engine. It is below the lower intake manifold.

 
3.6 oil cooler on a Ram ProMaster
 

What are some signs that my oil cooler/oil filter housing is leaking?

One of the main signs is an oil leak running down the back of the engine. The leaking oil puddles up in the “V” of the engine and then runs down the back. This kind of leak can also run onto the transmission.

 
3.6 leaking oil on a Ram ProMaster
 

What does the oil cooler/oil filter housing do?

The oil cooler/oil filter housing is used to filter and then cool the engine oil before it is to be used again.

ALLDATAdiy.com - Leading source of online automotive diagnostic & repair information! Shop now

What causes the oil cooler/oil filter housing to go bad?

The o-rings on the bottom of the oil cooler/oil filter housing leak over time. In some cases, the oil cooler/oil filter housing will become cracked and start to leak.

How hard is it to replace the oil cooler/oil filter housing?

Replacing one of these components can be challenging for the less experienced mechanic. Special tools like a fuel line disconnect tool and a plastic clip remover are needed.

Multiple parts have to be taken off like the upper and lower intake manifolds, to reach the oil cooler/oil filter housing.

With the upper and lower intake manifolds off, the intake valves are exposed. Small parts like bolts can easily fall into the cylinders if you are not careful.

How much does it cost to fix a Ram ProMaster oil leak?

If it is your oil cooler/oil filter housing that is leaking, it may cost $100-$250 for the part itself. Depending on the mechanic’s labor rate, it can cost up to $900.


Frequently Asked Question:

Where do I find wiring diagrams and step-by-step repair procedures for Rams?

The best online resource I use is Alldatadiy.com.

I used it for this case study to find the correct procedure for this Ram ProMaster.

There are plenty of diagnostic aids to test many electrical components and get to the root of any problem.

10% Off One Month Subscription at AllDataDIY with Code 4HYBRIDREPCA. Shop Now!

ALLDATAdiy.com - Leading source of online automotive diagnostic & repair information! Shop now

Disclaimer and Disclosure:

Due to factors beyond the control of DiagnosticMechanic.com, it cannot guarantee against unauthorized modifications of this information, or improper use of this information. DiagnosticMechanic.com assumes no liability for property damage or injury incurred as a result of any of the information contained in this website. DiagnosticMechanic.com recommends safe practices when working with power tools, automotive lifts, lifting tools, jack stands, electrical equipment, blunt instruments, chemicals, lubricants, or any other tools or equipment seen or implied in this website. Due to factors beyond the control of DiagnosticMechanic.com, no information contained in this website shall create any express or implied warranty or guarantee of any particular result. Any injury, damage or loss that may result from improper use of these tools, equipment, or the information contained in this website is the sole responsibility of the user and not DiagnosticMechanic.com.

DiagnosticMechanic.com is a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for sites to earn advertising fees by advertising and linking to Amazon.com. In many of our case studies, articles, and tool reviews, we may earn a small commission when readers purchase products through our links.

Previous
Previous

Chrysler 200 With 3.6L Leaking Oil (Look HERE first)

Next
Next

Ram 1500 With 3.6L Leaking Oil (Look HERE first)